Reading time ( words)
IPC's VP of Government Relations, John Hasselman, explains IPC's "meet the policy makers" initiative (site visits by congressmen) to help build and broaden relationships with these decision makers. He also talks about IMPACT 2016 (in mid-April, formerly called Capitol Hill Day) for electronics executives and the importance of bringing science-based facts to the table so that we can be involved in legislative decisions that affect our industry.
Watch the interview here.
Andy Shaughnessy, Design007 Magazine
It’s officially fall now, and in Atlanta the temperature has plummeted to the mid-80s. We’ve all bumped our air conditioners up to 74 degrees. That means it’s trade show season, and I’ve been busy looking for my suitcase. This week, we have an assortment of news about associations, education, and advocacy, as well as another installment of our Printed Electronics Roundtable. And if you’re looking for a job, you are in luck; our jobConnect007 section is chock-full of open positions at all levels in this industry.
Suhani Chitalia and Kelly Scanlon, IPC
Leading companies in the electronics manufacturing industry are highly intentional about their environmental, social and governance (ESG) priorities, with climate change and energy use among the most closely scrutinized issues, an IPC analysis shows. As part of IPC’s ESG for Electronics initiative, IPC is interested in developing resources for members on the most common ESG methods and priorities of leading companies across the electronics value chain. In support of this, IPC has preliminarily analyzed the ESG reports of approximately a dozen companies in selected portions of the industry.
Pete Starkey, I-Connect007
“Summer is over, now it's back to work!” This was the opening line of the invitation to the 18th EIPC Technical Snapshot webinar, Sept. 14, following the theme of advances in automotive electronics technology, introduced and moderated by EIPC President Alun Morgan. The first presentation, entitled "The fully printed smart component—combining additive manufacturing and sensor printing," came from Jonas Mertin, a thin-film processing specialist at the Fraunhofer Institute for Laser Technology.