Reading time ( words)
Prototron Circuits Operations Manager Mike Graves explains how his company's focus on customer service, including helping with PCB designs, has made Prototron "America's Board Shop." He also discusses their expansion into flex and HDI technology, and their efforts to achieve AS9100 certification.
To watch this video, click here.
Andy Shaughnessy, Design007 Magazine
We’re still not officially into summer yet, but Atlanta is bringing the heat, baby! It’s hit 97 degrees a few times this week, and I now have a fan aimed right at my face. At least it’s nice and humid too. I’m glad I don’t wear make-up. And it’s been a hot week in the circuit board community. This week, Eltek reported a fire at a board shop in Israel, and Flex committed to building a 145,000-square-foor facility in Jalisco, Mexico to serve the electric and autonomous vehicle segment.
Ed Acheson, Cadence Design Systems
With the current design transfer formats, rigid-flex designers face a hand-off conundrum. You know the situation: My rigid-flex design is done so now it is time to get this built and into the product. Reviewing the documentation reveals that there are tables to define the different stackup definitions used in the design. The cross-references for the different zones to areas of the design are all there, I think. The last time a zone definition was missed, we caused a costly mistake.
I-Connect007 Editorial Team
In just 15 minutes, flex expert Joe Fjelstad will teach you about implementing this useful technology into your manufacturing operation. Joe suggests you start with defining your end-product requirements and understanding cost and product life cycle expectations, as well as end-user needs. He further addresses the many considerations with adopting this useful technology.