October 2020 Issue of Design007 Magazine Available Now


Reading time ( words)

Even the most experienced hikers can get lost if they don’t have a map. The same holds true in the world of PCB design and manufacturing—if your company doesn’t have a technology roadmap, it’s hard to know where you’re going technologically.

In the October issue of Design007 Magazine, we take a look at a variety of technology roadmaps related to PCB design, and some of the milestones that may be in our not-too-distant future. Preview or download the magazine to your device for future reference on the virtual newsstand and available for delivery in your e-mailbox by subscribing here.

Share




Suggested Items

I-Connect007 Editor’s Choice: Five Must-Reads for the Week

06/17/2022 | Andy Shaughnessy, Design007 Magazine
We’re still not officially into summer yet, but Atlanta is bringing the heat, baby! It’s hit 97 degrees a few times this week, and I now have a fan aimed right at my face. At least it’s nice and humid too. I’m glad I don’t wear make-up. And it’s been a hot week in the circuit board community. This week, Eltek reported a fire at a board shop in Israel, and Flex committed to building a 145,000-square-foor facility in Jalisco, Mexico to serve the electric and autonomous vehicle segment.

Additive Manufacturing Requires Additive Design Techniques

05/09/2022 | Luca Gautero, SUSS MicroTec
Although I am not a designer by trade, I want to share my thoughts on what additive manufacturing means for designers, especially how it relates to solder mask. In this article, you will learn what topics I feel are the most important to address.

Additive Design: Same Steps, Different Order

04/12/2022 | I-Connect007 Editorial Team
We recently spoke with Dave Torp, CEO of Winonics, about the company’s additive and semi-additive processes and what PCB designers need to know if they’re considering designing boards with these new technologies. As Dave explains, additive design is not much different from traditional design, but the steps in the design cycle are out of order, and additive designers must communicate with their fabricators because so much of the new processes are still proprietary.



Copyright © 2022 I-Connect007. All rights reserved.