Words of Advice: Making Life Easier for Fabrication and Assembly


Reading time ( words)

In a recent survey, we asked the following question: What steps do you take to make the job easier for your fabrication and assembly providers? Here are a few of the answers, edited slightly for clarity.

  1. Try to insist that client has fab house run Valor DFM.
  2. Consult them first with any questions.
  3. Don’t use more demanding fab technology than absolutely necessary, including tolerances.
  4. Review Gerbers before their release.
  5. Go straight to the vendors for a stackup.

Share

Print


Suggested Items

Meet Eran Navick, I-Connect007 Columnist

01/31/2020 | I-Connect007 Editorial Team
Meet Eran Navick, one of I-Connect007’s newest columnists! In his columns, Eran will discuss technology around the world, touching on all aspects of PCB technology, especially high technology. Eran has been in the PCB business for over 25 years and held key positions in PCB companies, including as a PCB designer and applications engineer.

Communication, Part 6: The Importance of Technology Fit

11/08/2019 | Steve Williams, The Right Approach Consulting LLC
In the final installment of this series on how PCB fabricators and designers can better communicate, Bob Chandler from CA Design and Mark Thompson from Prototron Circuits discuss the importance of “technology fit” and how this concept impacts the synergy of the two parties involved.

Insulectro and DuPont Experts Talk Flex Design

09/25/2019 | Mike Creeden, CID+, Insulectro
I recently spoke with Insulectro’s Chris Hunrath and DuPont’s Steven Bowles at the DuPont Technology and Innovation Center in Sunnyvale, California. We discussed a variety of topics related to flex design, including the support structure that’s needed in flex design, the everchanging world of flex materials, and the need for working with a flex fabricator as early as possible in the flex design cycle.



Copyright © 2020 I-Connect007. All rights reserved.