Mentor Webinar: Correct Model Assignments for SI (Full Flow)

Reading time ( words)

Mentor, a Siemens business will hold a webinar on “Correct Model Assignments for SI (Full Flow)“ on February 21, 2019, 8:30 a.m. - 9:30 a.m. US/Pacific.

Signal Integrity simulation is only as good as your simulation models.  This webinar will show best practices to assign models for your components in HyperLynx SI.  Learn how to setup files to automatically map models to components brought into HyperLynx.  Once your models are setup, simulation can be easy and accurate.

About the Presenter

Kyle Lake is an Applications Engineer for Oasis Sales. Before joining Oasis, Kyle was a Corporate Marketing Engineer at Mentor Graphics where he was responsible for helping customers identify solutions to their PCB design issues.

His primary focus at Oasis is supporting advanced solutions: PADS Professional, the Xpedition Enterprise Platform and PCB simulation tools for high-performance designs.​

05/03/2017 | Alistair Little, Electrolube

Over the last few columns, I’ve given readers pointers on virtually every aspect of potting and encapsulation resins, ranging from their formulations and special properties to their applications, benefits and limitations. It’s probably high time, therefore, to take a step back from the do's and don’ts and focus instead on how these resins are bringing very real benefits to practical electronic and electrical engineering applications. A good starting point is to look at the special requirements of an industry that is enjoying explosive growth: LED lighting.

07/31/2013 | Mark Thompson, CID, Prototron Circuits

At last, PCB designers are finally realizing the power they wield: They have the power to design profit into the board, or, conversely, increase costs and remove profit from the PCB. Mark Thompson reviews the challenges fabricators routinely face and presents typical DFP solutions affecting the bottom line.