-
- News
- Books
Featured Books
- design007 Magazine
Latest Issues
Current IssueLevel Up Your Design Skills
This month, our contributors discuss the PCB design classes available at IPC APEX EXPO 2024. As they explain, these courses cover everything from the basics of design through avoiding over-constraining high-speed boards, and so much more!
Opportunities and Challenges
In this issue, our expert contributors discuss the many opportunities and challenges in the PCB design community, and what can be done to grow the numbers of PCB designers—and design instructors.
Embedded Design Techniques
Our expert contributors provide the knowledge this month that designers need to be aware of to make intelligent, educated decisions about embedded design. Many design and manufacturing hurdles can trip up designers who are new to this technology.
- Articles
- Columns
Search Console
- Links
- Events
||| MENU - design007 Magazine
Estimated reading time: 1 minute
The State of High-Speed Materials
Choosing the right material for your PCB was so simple a few decades ago. All but the most high-tech PCBs were constructed with FR-4. The lowly FR-4 has been improved and re-engineered many times in the past few decades, and rumors of its demise have proven unfounded.
But at today’s high speeds, FR-4 often doesn’t measure up, and designers must select an advanced low-loss PCB material with low Df and Dk values that isn’t prohibitively expensive or terribly difficult for fabricators to register during lamination. High-speed PCB signals now exhibit characteristics previously seen only in the RF and microwave world, requiring PCB designers to consider using lok-Dk RF materials such as PTFE and Teflon, which are much “softer” than FR-4 and tougher for the fabricator to work with.
We started out with a reader survey. We asked, “If you are a PCB fabricator or designer, what are the greatest challenges for you working with high-speed materials?” and some of the answers were quite interesting.
Answers included:
- Dielectric constant is too high
- Material movement
- Getting accurate performance data
- Customer knowledge
- Performance for signal integrity
- Getting accurate dielectric material properties from data sheets
- Availability
- Too many materials to stock
- Mechanical stability in the z-axis
- Materials adhesion
- As a PCB fabricator, understanding designers' needs
- Hole wall quality
- Educating the customers on what they actually need
- Impedance control
- Lead time
- Cost
Many of the fabricators’ biggest challenges were related to manufacturability. The more high-tech materials are softer and pose problems with adhesion and registration. But many of the problems cited by designers centered on the lack of good data for advanced materials.
To read this entire column, which appeared in the April issue of The PCB Design Magazine, click here.
More Columns from The Shaughnessy Report
The Shaughnessy Report: Design Takes Center Stage at IPC APEX EXPOThe Shaughnessy Report: The Myriad Opportunities—and Challenges
The Shaughnessy Report: In Bed With Embedded
The Shaughnessy Report: Pulling Together
The Shaughnessy Report: The Winds of Change
The Shaughnessy Report: Trace Oddity
The Shaughnessy Report: Simply Speaking
The Shaughnessy Report: Exploring High-reliability Fabrication