Vertical Conductive Structures, Part 4: Tuning Your Signal Performance


Reading time ( words)

The objective of this article is to demonstrate the possibility of using a stitching element as an alternative to the point-to-point connections that are used with traditional via technology. Point-to-point connections have the best performance in terms of signal integrity (one via less in the connection that distorts the signal). A via is mainly a capacitive element that causes signal loss/ dispersion.

This study focuses on developing a layer transition element that minimises the loss and dispersion. We will use VeCS-2 technology (blind/hybrid) construction (Figure 1).

The advantage of using a stitching via is that we can use “traditional” orthogonal routing, which is very efficient in signal layer utilization. However, in some instances, orthogonal or Manhattan routing could yield a longer trace length, which could lead to a higher loss due to the dielectric and conductive losses.

Joan-vert-fig1.jpg

To read this entire article, which appeared in the October 2019 issue of PCB007 Magazine, click here.

Share

Print


Suggested Items

I-Connect007 Editor’s Choice: Five Must-Reads for the Week

04/23/2021 | Andy Shaughnessy, I-Connect007
This week, we bring you a wide swath of news, columns, and articles from the past week. Altium announced a new cloud platform that connects design stakeholders with users of its Altium 365 environment. Cadence Design Systems has acquired a company that develops computational fluid dynamics technology to help expand its system analysis offerings.

Time, Space, Structure, and Model Analysis of CCL Price Increase

04/19/2021 | Hu Yang, Zhongtai Securities Research Center
According to the CCL Association, copper foil accounts for the largest proportion of raw materials (traditional CCL uses epoxy resin, glass fiber cloth and copper as raw materials). Copper foil in thin plate accounts for about 30% of the overall cost; in thick plate copper accounts for 50%. In CCL production, using Shengyi Technology and Chaohua Technology as examples, the cost of raw materials accounts for about 88% of the total cost, with labor accounting for about 4%. Other costs such as equipment depreciation account for about 8%.

PCB Sourcing Using PCQR2

03/30/2021 | Al Block, Naji Norder, and Chris Joran, National Instruments
In a global market, it is often difficult to determine the best PCB suppliers for your technology needs, while also achieving the lowest costs for your products. Considering each PCB supplier has their own niche in terms of equipment, process, and performance, uniform test data from the IPC-9151D Process Capability, Quality, and Relative Reliability (PCQR2) Benchmark Test Standard can help find the right source for the board based on its specific technology requirements.



Copyright © 2021 I-Connect007. All rights reserved.