Words of Advice: What Feature Would You Like to See in Your CAD Tool?


Reading time ( words)

In a recent survey, we asked the following question: What feature would you like to see in your CAD tool? Here are a few of the answers, edited slightly for clarity.

  1. Proper support for flex stiffeners and upgraded signal integrity simulation.
  2. Compatibility and flexibility in and EDA design tool is a challenge.
  3. PCB current carrying capacity DRC.
  4. A better process flow.
  5. Better documentation.

Share

Print


Suggested Items

Why We Simulate

04/29/2021 | Bill Hargin, Z-zero
When Bill Hargin was cutting his teeth in high-speed PCB design some 25 years ago, speeds were slow, layer counts were low, dielectric constants and loss tangents were high, design margins were wide, copper roughness didn’t matter, and glass-weave styles didn’t matter. Dielectrics were called “FR-4” and their properties didn’t matter much. A fast PCI bus operated at just 66 MHz. Times have certainly changed.

Bridging the Simulation Tool Divide

04/12/2021 | I-Connect007 Editorial Team
Todd Westerhoff of Siemens EDA recently spoke with the I-Connect007 Editorial Team about the divide between users of high-powered enterprise simulation tools and those who need a more practical tool for everyday use, and how Siemens is working to bridge the gap. Todd also shared his views on why so many engineers do not use simulation, as well as advice for engineers just getting started with simulation tools.

Barry Olney’s High-Speed Simulation Primer

04/09/2021 | I-Connect007 Editorial Team
The I-Connect007 editorial team recently spoke with Barry Olney of iCD about simulation. Barry, a columnist for Design007 Magazine, explains why simulation tools can have such a steep learning curve, and why many design engineers are still not using simulation on complex high-speed designs.



Copyright © 2021 I-Connect007. All rights reserved.