PCB Design Industry Roundtable at SMTA Atlanta April 20


Reading time ( words)

If you’re an Atlanta-area designer, you won’t want to miss this. This informal discussion, hosted by UPMG President Pete Waddell, will focus on the world of PCB design, its challenges, its future, with a focus on how to facilitate communication with the entire PCB supply chain, including fabrication and assembly. If you're a PCB designer or engineer, provide EDA software or just want to understand how to better work with a design group, join us for a casual conversation that promises to be a lively look at the world of PCB design and beyond.

When:
Wednesday, April 20, 2016
10 am – 3 pm

Where:
Infinite Energy Center (formerly Gwinnett Center)
6400 Sugarloaf Parkway
Duluth, Georgia 30097

For more information, click here.

Share

Print


Suggested Items

‘The Trouble with Tribbles’

06/17/2021 | Dana Korf, Korf Consultancy
The original Star Trek series came into my life in 1966 as I was entering sixth grade. I was fascinated by the technology being used, such as communicators and phasers, and the crazy assortment of humans and aliens in each episode. My favorite episode is “The Trouble with Tribbles,” an episode combining cute Tribbles, science, and good/bad guys—sprinkled with sarcastic humor.

IPC-2581 Revision C: Complete Build Intent for Rigid-Flex

04/30/2021 | Ed Acheson, Cadence Design Systems
With the current design transfer formats, rigid-flex designers face a hand-off conundrum. You know the situation: My rigid-flex design is done so now it is time to get this built and into the product. Reviewing the documentation reveals that there are tables to define the different stackup definitions used in the design. The cross-references for the different zones to areas of the design are all there, I think. The last time a zone definition was missed, we caused a costly mistake.

Why We Simulate

04/29/2021 | Bill Hargin, Z-zero
When Bill Hargin was cutting his teeth in high-speed PCB design some 25 years ago, speeds were slow, layer counts were low, dielectric constants and loss tangents were high, design margins were wide, copper roughness didn’t matter, and glass-weave styles didn’t matter. Dielectrics were called “FR-4” and their properties didn’t matter much. A fast PCI bus operated at just 66 MHz. Times have certainly changed.



Copyright © 2021 I-Connect007. All rights reserved.