IPC APEX EXPO: New Arlon Materials Address Design and Fab Challenges


Reading time ( words)

Brad Foster, VP and general manager of Arlon, discusses some new laminates and pre-pregs that help designers and fabricators address a variety of challenges. He explains how Arlon works with customers to help them with stack-ups and other issues. 

To watch this video, click here.

Share


Suggested Items

Dan Beeker’s AltiumLive Keynote: It's All about the Space

10/18/2017 | Barry Matties, Publisher, I-Connect007
Dan Beeker of NXP Semiconductors was a keynote speaker at the recent AltiumLive 2017 event in San Diego. His presentation focused primarily on the design of three-dimensional structures and how it’s all about space. I caught up with Dan, and we discussed his presentation, his background and career, and what kind of advice he would give to young PCB designers.

Whose Fault is it When the Board Fails?

06/07/2017 | Andy Shaughnessy, PCBDesign007
In an upcoming issue of The PCB Design Magazine, we will discuss a question that you've undoubtedly faced in your job: Whose fault is it when the board fails? Of course, everyone likes to blame the PCB designer. But think about it. Is the board shop at fault, or perhaps the EMS provider? Is it the customer's fault, or does the designer bear some of the blame after all? Take this quick survey and let your voice be heard!

Steve Robinson Discusses APCT’s Tenfold Expansion

05/24/2017 | Andy Shaughnessy, PCBDesign007
Steve Robinson, CEO of APCT, a PCB fabricator in Silicon Valley, has led the company to impressive growth since he acquired it nearly 10 years ago. I ran into Steve at DesignCon 2017, and we sat down to discuss the company’s remarkable transformation and his focus on working with PCB designers and engineers to create advanced, high-speed PCBs.



Copyright © 2017 I-Connect007. All rights reserved.