Arlon’s John Wright Discusses New High-Performance Materials


Reading time ( words)

During productronica, European Editor Pete Starkey interviewed Engineering/Quality Manager John Wright of Arlon. They discussed Arlon’s new 85HP ceramic-filled polyimide, as well as a non-woven aramid material, suitable for space applications, that is a drop-in replacement for a similar material discontinued by a competitor in 2006.

To watch this interview, click here.

Share




Suggested Items

A Textbook Look: Signal Integrity and Impedance

05/18/2022 | Pete Starkey, I-Connect007
Believing that I knew a bit about signal integrity and controlled impedance, I was pleased to take the opportunity to connect with an educational webinar that I hoped would extend my knowledge. In the event I was surprised at how little I actually knew, and the webinar was an excellent learning opportunity. The webinar was introduced and expertly moderated by Anna Brockman of Phoenix Contact in Germany.

Book Excerpt: 'The Printed Circuit Designer’s Guide to… High Performance Materials', Chapter 1

03/17/2022 | I-Connect007 Editorial Team
Choosing the right material for your application can be a major challenge. These are “cost to performance” decisions that need to be made to select material that will meet the expected performance requirements and the desired cost targets. Selecting a material that meets cost targets but fails to perform in prototype development testing results in costly revision spins, cost increases and delays to market. Chapter 1 of this book helps readers understand what resin choices to make for optimal electrical performance.

New Book From Isola Highlights Importance of Material Selection

01/14/2022 | I-Connect007 Editorial Team
In "The Printed Circuit Designer’s Guide to... High Performance Materials," the latest release from I-007eBooks, readers will learn how to overcome challenges associated with choosing the right material for their specific application. Author Michael Gay of Isola provides a clearer picture of what to know when determining which material is the most desirable for which products. PCB materials and DFM expert Mark Thompson says, “I love this book, particularly the sections on the effects of the glass weave, the history of laminate, and the difference between Dk and effective Dk."



Copyright © 2022 I-Connect007. All rights reserved.