-
- News
- Books
Featured Books
- design007 Magazine
Latest Issues
Current IssueLevel Up Your Design Skills
This month, our contributors discuss the PCB design classes available at IPC APEX EXPO 2024. As they explain, these courses cover everything from the basics of design through avoiding over-constraining high-speed boards, and so much more!
Opportunities and Challenges
In this issue, our expert contributors discuss the many opportunities and challenges in the PCB design community, and what can be done to grow the numbers of PCB designers—and design instructors.
Embedded Design Techniques
Our expert contributors provide the knowledge this month that designers need to be aware of to make intelligent, educated decisions about embedded design. Many design and manufacturing hurdles can trip up designers who are new to this technology.
- Articles
- Columns
Search Console
- Links
- Events
||| MENU - design007 Magazine
Design for Manufacturing: The 10 Commandments of Design for Assembly
July 24, 2013 |Estimated reading time: 1 minute
You might think that most PCB designers would know how to avoid the most obvious blunders that can gum up board assembly. But you would be wrong. I can tell you from daily experience that we’re just not there yet. So allow me to propose The 10 Commandments of DFA.
1st Commandment
Be sure all indicators are present. The leading show-stopper in assembly is missing pin 1 indicators or component polarity/orientation indicators on the silkscreen. Nearly 75% of the assembly orders my facility receives fail to identify the location of pin 1 for each IC, or they misrepresent or neglect to indicate the polarity of some capacitors, diodes, or LEDs.
Obey the convention for marking the polarity of diodes, including LEDs: Put a K on the silkscreen layer at the cathode end. Alternatively, use the electrical symbol for diodes in the correct orientation to guide assembly. Never indicate diode polarity based on the anode pad. Use a K to designate the cathode or line up the diode symbol in the correct position. Don’t substitute any other marks or your contractor will misinterpret what you intend.
To orient tantalum capacitors, tag the positive side with a plus symbol on the silkscreen. Remember, tantalum capacitors can ignite if mounted with swapped polarity. Short of reverse-engineering a schematic (and who bundles schematics with assembly files?) there’s no way for a contractor to figure out part polarity unless it’s clearly displayed.
Silkscreens must not interfere with pads, and symbols should not be printed beneath the body of any component.Read the full column here.Editor's Note: This column originally appeared in the April 2013 issue of The PCB Design Magazine.