March 2021 Issue of Design007 Magazine Available Now


Reading time ( words)

Keeping bad data out of your design involves a lot of detective work. Designers and design engineers need to assess the accuracy and completeness of data at every step of the design process. If one small error in a footprint or schematic goes unnoticed, the CAM engineer may be calling with bad news on Friday afternoon. So, in the March issue of Design007 Magazine, we asked our expert contributors to discuss their special operations and tactics for keeping bad data out of their designs.

Download your copy today on the virtual newsstand or subscribe here for delivery in your email inbox.  

Share

Print


Suggested Items

Turning ‘Garbage In, Garbage Out' into ‘Good In, Good Out’

03/23/2021 | Tamara Jovanovic, Happiest Baby
In the PCB design cycle, it is so easy to unintentionally introduce “garbage” into your system. Unless you have time to extensively check everything you bring in from an external source, it is very likely that something will not match up with your design data. In the end, this means you’ll have to put more work into your design and basically reverse-engineer a part that was supposed to save you time and effort.

Karen McConnell: Recipient of the IPC Raymond E. Pritchard Hall of Fame Award

03/11/2021 | Patty Goldman, I-Connect007
"I heard about IPC when I started a new job at UNISYS after graduating college. I moved from ASIC design to printed circuit boards," said Karen McConnell after being inducted into the Raymond E. Pritchard Hall of Fame. "At the time, in the late ’80s and early ’90s, there were rumors going around that printed circuit boards were going to disappear, and ASICs were going to take over the world. But something in printed circuit boards fascinated me. I minored in robotics in college as an electrical engineer and the data used to fabricate, assemble and test the boards is actually all robotic language. I was hooked."

The Key to Eliminating Bad Design Data: Constant Vigilance

03/09/2021 | I-Connect007 Editorial Team
The I-Connect007 editorial team recently met with Jen Kolar and Mark Thompson of Monsoon Solutions to discuss ways to eliminate bad data from the design process, whether that be from CAD libraries, parts vendors, chip makers, or customers themselves. They key in on some problems and obstacles that allow incorrect data into the design cycle, and then highlight possible solutions.



Copyright © 2021 I-Connect007. All rights reserved.