Real Time with… Altium Live Europe 2020: Rick Hartley’s Secrets of PCB Optimization


Reading time ( words)

Hartley gave a brief introduction to the circuit board manufacturing process, taking a basic four-layer multilayer as an example, and proceeding step by step through all of the principal stages, with his explanations aided by clear graphics. He made a particular point about non-uniform plating distribution on outer layers with unbalanced copper but advised against allowing the fabricator to fill spaces with thieving copper to even-out the plating because of potential induction effects. The designer would need to make modifications with manufacturability in mind whilst maintaining the signal integrity of the design. A copper pour, attached to ground or power, could help but might not be the answer.

Hartley-4.jpg

On the subject of etch-compensation, he advised designing at nominal conductor width and leaving it to the fabricator to calculate the appropriate etch-factors. “Don’t compensate for the fabricator’s needs. Make sure you design so they can produce your board. Know what they can and can’t produce, and design around their needs, then send them the design and leave them alone.”

Hartley-5.jpg

There were many more details to understand—he could easily have filled the other seven hours he mentioned—and many more questions to ask the fabricator: “Don’t assume. Talk to the fabricator, ask the questions, get to know the most knowledgeable person at every fab shop your company uses—someone who understands.”

Listening to Rick Hartley was like a breath of fresh air. And his one-hour (and a bit) session provided a wealth of advice on how to accomplish the goal of optimising designs for cost-effective, high-quality manufacturing.

Share




Suggested Items

Pulsonix Collision Avoidance to Bring Mechanical Capabilities Into ECAD

05/19/2022 | I-Connect007 Editorial Team
The I-Connect Editorial Team recently spoke with Bob Williams, managing director of Pulsonix. He discussed some of the new features in the upcoming version of the Pulsonix PCB design tool, Version 12, including collision avoidance and other 3D options that allow certain MCAD functions within the ECAD environment.

A Textbook Look: Signal Integrity and Impedance

05/18/2022 | Pete Starkey, I-Connect007
Believing that I knew a bit about signal integrity and controlled impedance, I was pleased to take the opportunity to connect with an educational webinar that I hoped would extend my knowledge. In the event I was surprised at how little I actually knew, and the webinar was an excellent learning opportunity. The webinar was introduced and expertly moderated by Anna Brockman of Phoenix Contact in Germany.

Designing in a Vacuum Q&A: Carl Schattke

05/11/2022 | Andy Shaughnessy, Design007 Magazine
Not long ago, I caught up with Carl Schattke, CEO of PCB Product Development LLC and a longtime PCB designer, for his thoughts on “designing in a vacuum.” As Carl points out, if you follow PCB design best practices, knowing the identity of your fabricator is not a “must-have.” He also offers some communication tips for discovering the information you do need, including one old-fashioned technique—just asking for it.



Copyright © 2022 I-Connect007. All rights reserved.