Freedom CAD’s Expert PCB Design Tips, Part 2


Reading time ( words)

When you’re designing complex PCBs, knowledge truly is power. The more PCB design tips, tricks, and techniques you know, the better your cutting-edge designs will be. With that in mind, we’re bringing you a series of PCB design tips, courtesy of Freedom CAD Services.

Design Tip #2
Don’t make your high-current traces too long.

Today’s PCB designs require more diligence in order to meet the requirements of today’s high-speed microprocessors. At higher data rates, insertion loss becomes more critical. This results in signal length limitations due to insertion loss, very tight impedance matching, short stub lengths, and the use of higher performance PCB laminates.

Want to know more? Check out the entire library of I-Connect007 micro eBooks. Scott Miller, chief operations officer of Freedom CAD Services, is the author of the eBook The Printed Circuit Designer’s Guide to… Executing Complex PCBsThis book provides a set of guidelines for designing the most complex, high-speed PCBs right the first time, every time. This book is a must-read for anyone designing today's sophisticated printed circuit boards.

Share

Print


Suggested Items

My View from CES 2021: Day 1

01/12/2021 | Dan Feinberg, Technology Editor, I-Connect007
What a difference a year makes. One year ago, those of us who cover and attend CES were going from one press conference to the next; this year, we are at home going from link to link. Confusing and challenging, yes, but there are some advantages: no masks, only five steps to get to a restroom, being able to have three of four events or more displaying on your screens at the same time and being able to download press kits as needed. So far, many new devices are being introduced, but of course, they are all online, so you wonder if some of them really exist or are truly operational as yet.

Lee Ritchey on Reducing Respins by One

12/30/2020 | I-Connect007 Editorial Team
I-Connect007 recently spoke with Lee Ritchey about the subject of continuous improvement with a focus on DFM, specifically looking at the benefits of reducing the number of respins by just one. A longtime instructor and one of the authors of Right the First Time: A Practical Handbook on High-Speed PCB and System Design, Lee has spent decades preaching the value of solid DFM practices, so we asked him to discuss why so many OEMs accept multiple respins with each design project and what designers could do to eliminate just one spin. He also shares some of the lessons in reducing respins that he learned in the early days of Silicon Valley.

EIPC Technical Snapshot: PCB Surface Finishes

12/28/2020 | Pete Starkey, I-Connect007
For the third in a series of Technical Snapshot webinars, EIPC chose to focus on PCB surface finishes, comparing specific properties, examining corrosion behaviour and discussing selection criteria for low-loss, high frequency applications.



Copyright © 2021 I-Connect007. All rights reserved.