Words of Advice: Flex Design Problems


Reading time ( words)

In a recent survey, we asked the following question: What are your biggest problems related to flex design? Here are just a few of the answers, edited slightly for clarity.

  1. Designing without knowing the design requirements.
  2. Mechanical dimensioning/sizing to fit the required application.
  3. Complexity: We don’t do enough flex to get good at it.
  4. No real issues. We’ve gained a lot of knowledge over the years.
  5. Flex cannot carry the current needed.

Share

Print


Suggested Items

John Michael Pierobon Discusses His Flex Design Class

10/01/2019 | Andy Shaughnessy, Design007 Magazine
If you’re new to flex design, you might want to check out an online course offered by All Flex, a flex fabricator. The course, Designing Flexible Circuits, was created by John Michael Pierobon. I asked John Michael to discuss his flexible circuit design course, and whether online curriculum can ever replace good old-fashioned live instruction.

Insulectro and DuPont Experts Talk Flex Design

09/25/2019 | Mike Creeden, CID+, Insulectro
I recently spoke with Insulectro’s Chris Hunrath and DuPont’s Steven Bowles at the DuPont Technology and Innovation Center in Sunnyvale, California. We discussed a variety of topics related to flex design, including the support structure that’s needed in flex design, the everchanging world of flex materials, and the need for working with a flex fabricator as early as possible in the flex design cycle.

Words of Advice: What are Your Biggest Design Challenges?

09/19/2019 | Andy Shaughnessy, Design007 Magazine
In a recent survey, we asked the following question: What are your biggest design challenges? Here are just a few of the answers, edited slightly for clarity.



Copyright © 2019 I-Connect007. All rights reserved.