Words of Advice: Your Company’s Design Process


Reading time ( words)

In a recent survey, we asked PCB designers to describe their company’s design process: Is it a rigid workflow they follow to the letter, or a process that allows for their individual techniques? Of course, the comments were illustrative.

  1. Just another “herding indecisive cats” situation.
  2. I adapt to the customer’s requirements and standards, but my process remains the same.
  3. I am an independent contractor, so it tends to vary some based on the client.
  4. We wing it.
  5. There isn’t a clear workflow.

Share

Print


Suggested Items

Words of Advice: Where Do You Get Involved in the Design Process?

07/18/2019 | Andy Shaughnessy, Design007 Magazine
In a recent survey, we asked the following question: Where in the process do you typically get involved with a design project? Here are a few of the answers, edited slightly for clarity.

Design Is a Pivotal Piece of the Puzzle

07/03/2019 | I-Connect007 Editorial Team
As a field applications engineer at TTM Technologies, which has fabrication and manufacturing locations around the world, Julie Ellis sees a wide variety of customer design requirements. In this interview with the I-Connect007 Editorial Team, Julie explains how PCB designers can influence the development of the PCB. She shares a variety of tips and tricks that designers can implement early in the design process to help optimize fabrication and assembly later on and keep small issues from becoming big problems downstream.

Words of Advice: When do You Get Involved in the PCB Design Cycle?

05/27/2019 | Andy Shaughnessy, Design007 Magazine
In a recent survey, we asked the following question: Where in the process do you typically get involved with a design project? Here are a few of the answers, edited slightly for clarity.



Copyright © 2019 I-Connect007. All rights reserved.