Mentor Webinar: PADS Designer Tips and Tricks


Reading time ( words)

Register now for this free webinar, scheduled for July 11. In this webinar, attendees will go through the steps involved in setting up PADS Designer for either the netlist flow or integrated flow, and some tips and tricks for existing users.

Who Should Attend

  • Electrical Designers
  • IT Engineers
  • Anyone using PADS Designer

What Attendees Will Learn

  • Setting up your company library structure
  • Using design templates for new project configuration
  • Implementing an effective company WDIR environment

Date

July 11, 2019

Time

8:30 AM PST/11:30 EST – 1 Hour

To register for this free webinar, click here.

Share




Suggested Items

Book Excerpt: An Introduction to The Printed Circuit Designer’s Guide to… Stackups

07/07/2022 | I-Connect007
To give readers a sample of The Printed Circuit Designer’s Guide to... Stackups—The Design within the Design, by Bill Hargin, we are providing the book's introduction. He writes, "Another book about stackups? If you’re asking this question, I’d like to know the book you’re thinking of, as I was looking for it a few years back. I have a pretty good PCB signal integrity (SI) library, and I’ve only found one chapter on stackup design so far."

What Happens When You Assume?

07/05/2022 | I-Connect007 Editorial Team
What is design with manufacturing and what does true DWM look like in operation? In this interview, I-Connect007 columnist Dana Korf explains what it will take to achieve total communication among all the stakeholders in the PCB development cycle. He also stresses the need for everyone involved in PCB design and manufacturing to stop making assumptions, even at the risk of being labeled as “that guy” who asks too many questions.

Master the Art of Communication With Manufacturers

06/30/2022 | Kyle Burk, KBJ Engineering
As mentioned in the May issue of Design007 Magazine, design is performed, at times, in a vacuum. But it doesn’t have to be that way. Whenever circumstances allow, design should be performed by communicating with all stakeholders throughout the design process, hence the emphasis on the word with in DWM. Communication can occur through personal correspondence such as email and voice conversations or through more formal design meetings—in person or through videoconferencing. No matter which means of communication you prefer, it’s important to communicate early and often with stakeholders involved in the downstream processes as you bring your project to realization.



Copyright © 2022 I-Connect007. All rights reserved.