DownStream Webinar March 27: Automate, Ease and Improve PCB Documentation


Reading time ( words)

There is a way to simplify the tedious task of creating PCB documentation. Not only does this revolutionary method save you time; it also streamlines the transfer of instructions from design to assembly and manufacturing.

Register now for this March 27 webinar today. Discover how BluePrint can change the way designers create, distribute and use PCB documentation.

To register for this webinar, click here.

Share

Print


Suggested Items

Albert Gaines: Design All Comes Down to Documentation

06/28/2019 | Andy Shaughnessy, Design007 Magazine
During SMTA Atlanta, I spoke with Albert Gaines of HiGain Design. We discussed Albert’s belief that everything starts with design and that too many engineers and designers focus solely on the final board at the expense of the documentation, which is a designer’s most important product. Do you consider your documentation to be a critical product?

Libraries: A Must-have for Design

06/17/2019 | Dan Feinberg
I-Connect007 was invited to attend a session of the Orange County Chapter of the IPC Designers Council (DC). Even though I have been an IPC member for over half a century (yes, almost since vacuum tubes dominated design), this was my first DC event.

EMA: Cadence Moves Simulation Further Up in the Design Cycle

03/15/2019 | Andy Shaughnessy, Design007 Magazine
Cadence Design Systems recently integrated more of its Sigrity capabilities into the front end of its PCB design tools. During DesignCon, Chris Banton of EMA Design Automation spoke with me about how this drive for “model-less analysis” benefits the PCB designer who can now access signal and power integrity, DFM, and electrical rule checking functionality early in the design process and have fewer issues later.



Copyright © 2019 I-Connect007. All rights reserved.