Joe Clark Discusses DownStream’s Updated Tool Lineup and IPC-2581


Reading time ( words)

DownStream Technologies recently revamped their entire product line, from CAM350 through BluePrint-PCB. DownStream co-founder Joseph Clark and Guest Editor Kelly Dack discuss some of these updates, including a new GUI and capabilities such as 3D analysis, as well as news about IPC-2581.

To watch this interview, click here.

Share

Print


Suggested Items

Libraries: A Must-have for Design

06/17/2019 | Dan Feinberg
I-Connect007 was invited to attend a session of the Orange County Chapter of the IPC Designers Council (DC). Even though I have been an IPC member for over half a century (yes, almost since vacuum tubes dominated design), this was my first DC event.

XNC Format: Gerber Takes Data Into the Future

05/20/2019 | Denis Morin, Karel Tavernier, Jean-Pierre Charras, and Marius Matioc
The problem is that so many NC files are of deplorable quality because the NC format was never designed as a data transfer format. It has always been a machine driver and contains all sorts of information that a drilling machine needs, but that is irrelevant and confusing for data exchange.

Learning to Be More Flexible: Case Studies on Improving FPC Design

05/14/2019 | Todd MacFadden, Bose Corporation
As miniaturization requirements force manufacturers to pack more functionality into ever-smaller packages, it becomes more difficult to conform to IPC construction recommendations. Achieving robust FPCs requires frequent, iterative interaction internally among the mechanical, electrical, and PCB design teams, as well as with the fabricators and assemblers. The sooner in the design cycle you can engage the supplier and assembler, the better.



Copyright © 2019 I-Connect007. All rights reserved.