RTW IPC APEX EXPO 2019: For Elmatica, the Future is All About Data


Reading time ( words)

At IPC APEX EXPO 2019, Guest Editor Judy Warner sits down with Elmatica CEO Didrik Bech to discuss the company's business model and CircuitData, their award-winning open-source PCB design data language that is designed to facilitate existing design data formats, not replace them. As Bech says, the future is all about data. 

To watch this video at our Real Time with... IPC APEX EXPO 2019 site, click here.

Share

Print


Suggested Items

Design for the Unknown

06/20/2019 | Kelly Dack, CID+, EPTAC
Our industry loves DFx, also known as the “Design Fors.” As PCB designers, we not only design for manufacturability (DFM) but we design for assembly, reliability, cost, test, and many more factors which we like to lump together as DFx. But now, I think it’s time we embrace a new DFx: Design for the Unknown, or DFU.

Libraries: A Must-have for Design

06/17/2019 | Dan Feinberg
I-Connect007 was invited to attend a session of the Orange County Chapter of the IPC Designers Council (DC). Even though I have been an IPC member for over half a century (yes, almost since vacuum tubes dominated design), this was my first DC event.

Words of Advice: Planning a New Design

06/06/2019 | The I-Connect007 Team
In a recent survey, we asked the following question: What do you think is the most important thing a designer should remember when planning a new PCB design? Here are a few of the answers, edited slightly for clarity.



Copyright © 2019 I-Connect007. All rights reserved.