Zuken to Hold Fall Webinar Series


Reading time ( words)

Zuken’s Fall Webinar Series will run from September 2018 through March 2019. The company will be covering a wide range of topics from Silicon Expert to E3.series MCAD co-design.

Each webinar will cover a common design challenge, present a solution and then demonstrate that solution. The goal is to provide you with take-aways that you can apply immediately to your daily activities.

Share

Print


Suggested Items

EMA: Cadence Moves Simulation Further Up in the Design Cycle

03/15/2019 | Andy Shaughnessy, Design007 Magazine
Cadence Design Systems recently integrated more of its Sigrity capabilities into the front end of its PCB design tools. During DesignCon, Chris Banton of EMA Design Automation spoke with me about how this drive for “model-less analysis” benefits the PCB designer who can now access signal and power integrity, DFM, and electrical rule checking functionality early in the design process and have fewer issues later.

Words of Advice: What are Your Biggest Design Challenges?

03/11/2019 | Andy Shaughnessy, Design007 Magazine
In a recent survey, we asked the following question: What are your biggest design challenges? Here are just a few of the answers, edited slightly for clarity.

Todd Westerhoff Discusses His New Position and Much More

03/07/2019 | Andy Shaughnessy, Design007 Magazine
At DesignCon, I met with our old friend Todd Westerhoff, a veteran signal integrity engineer. Todd joined Mentor, a Siemens Business, since we last spoke. We discussed his new job responsibilities, his drive to get more designers and engineers to use SI tools, and the increasing value of cost-reduced design techniques versus overdesigning PCBs.



Copyright © 2019 I-Connect007. All rights reserved.