Mentor White Paper--Concepts of Power Integrity: Controlling Impedance Across a Bare Cavity


Reading time ( words)

The power distribution network (PDN) is the path from the power supply source (VRM) to the ICs (active devices). At low impedance, the PDN delivers adequate current to the receiver, enabling the PCB to function as desired.

Without a low-impedance path across the PDN, noise can propagate throughout a PCB, causing bit errors, voltage ripples, timing violations, and more. This white paper by Fadi Deek of Mentor, a Siemens Business, examines how impedance can be controlled in the PDN cavity. 

To download this free white paper, click here.

Share

Print


Suggested Items

EM Modeling: The Impact of Copper Ground Pour on Loss and Impedance

05/02/2019 | Chang Fei Yee, Keysight Technologies
This article briefly introduces the general purposes of copper ground pour on printed circuit boards. Subsequently, the impact of copper ground pour on PCB channel loss in terms of insertion loss and impedance in terms of time domain reflectometry (TDR) is studied with electromagnetic modeling using Mentor HyperLynx.

Impact of Serpentine Routing on Multi-gigabit Signal Transmission

11/29/2018 | Chang Fei Yee, Keysight Technologies
Serpentine is a technique to minimize skew or misalignment of differential pairs. The number of segments and intra-pair spacing of serpentining impacts the high-speed signal transmission. As the intra-pair gap is enlarged for serpentining, the characteristic impedance of the PCB trace in differential mode will rise. This leads to impedance discontinuity, signal reflection, and ultimately, attenuation. The signal attenuation is heavily dependent on the number of segments and intra-pair spacing of the serpentine.

Advanced Stackup Planning with Impedance, Delay and Loss Validation

08/02/2018 | Yuriy Shlepnev, Simberian
A typical PCB design usually starts with the material selection and stackup definition—the stackup planning or design exploration stage. How reliable are the data provided by the material vendors and PCB manufacturers? Can we use these data to predict trace width and spacing for the target trace impedance or to calculate delays or evaluate the loss budget?



Copyright © 2019 I-Connect007. All rights reserved.