Irridian Invests in New Printed Circuit Board Design Software Suites


Reading time ( words)

Recently acquired by Hindley Circuits, Irridian Industrial Electronics, has invested in introducing state-of-the-art PCB design software to significantly enhance the accuracy and speed of its design services.

The new Cadstar and Altium design software platforms have modern and interactive user interfaces. The cutting-edge design software platforms will allow us to design complex multilayered printed circuit boards while also incorporating high speed design requirements.

Both the Cadstar and Altium platforms allow all aspects of the PCB design cycle to be addressed – right from schematic capture and PCB layout through to documentation and simulation – meaning that our PCB designers can be seamlessly connected to all elements of the design process. We have already seen the benefits of this thanks to a rapid increase of speed and accuracy across the whole process.

We have been greatly impressed by our existing customers interest in Irridians design services and look forward to sharing with them the benefits that the new software will bring to our service offering. We are currently looking to hire an additional experienced PCB Designer in the very near future

Share

Print


Suggested Items

Words of Advice: What Concerns You About the Future?

02/14/2029 | Andy Shaughnessy, Design007 Magazine
In a recent survey, we asked the following question: What concerns do you have about the future? Here are just a few of the answers, edited slightly for clarity.

Effects of PCB Fiber Weave on High-Speed Signal Integrity

12/31/2018 | Chang Fei Yee, Keysight Technologies
This article studies the effect of PCB fiber weave on signal integrity in terms of mode conversion and differential channel loss due to intra-pair skew. The study used Keysight ADS 2DEM simulation to observe s-parameter (i.e., insertion loss and differential to common-mode conversion) and an eye diagram for signal transmission at 1 Gbps and 10 Gbps.

Calculation of Frequency-Dependent Effective Roughness Dielectric Parameters for Copper Foil Using Equivalent Capacitance Models

01/02/2019 | Marina Y. Koledintseva, Metamagnetics Inc.*, and Tracey Vincent, CST of America
Knowledge of the correct parameters of laminate PCB dielectrics refined from any copper foil roughness impact and the proper foil roughness characterization are important constituents of modeling high-speed digital electronics designs.



Copyright © 2019 I-Connect007. All rights reserved.