Frontline's InStack Viewer Helps Designers and Fabricators


Reading time ( words)

Ben Quarles, software solultions business manager at Frontline, and Editor Andy Shaughnessy discuss the new InStack Viewer, which allows PCB designers and fabricators to investigate impedances, material properties, and other attributes of the correct stackup.

To watch this interview, click here.

Share

Print


Suggested Items

Martin Cotton’s Parting Shot

12/19/2018 | Pete Starkey, I-Connect007
Martin Cotton is a unique personality in the PCB industry. As Cotton says, “I’m a designer—look at my haircut!” Cotton gave the keynote at the Institute of Circuit Technology’s 2018 Harrogate Seminar, challenging his audience to consider laminate dielectric properties in the context of power and cost in a presentation entitled 'The Effect of the Dk of a PCB Laminate on the Cost-effectiveness of Office Rental Space. Intrigued?' Read on!

Thermal Management Materials: Easing the Decision-Making Process

08/02/2018 | Jade Bridges, Electrolube
There are many different types of thermally conductive materials, and choosing between them will be dictated by production requirements and application design, as well as critical performance factors that must be achieved.

Making the Most of PCB Materials for 5G Microwave and mmWave Amps

06/13/2018 | John Coonrod, Rogers Corporation
Ready or not, 5G is coming, and it will require the right circuit materials for many different types of high-frequency circuits, including power amplifiers. 5G represents the latest and greatest in wireless technology, and it will be challenging to design and fabricate, starting with the circuit board materials, because it will operate across many different frequencies, such as 6 GHz and below, as well as at millimeter-wave frequencies (typically 30 GHz and above).



Copyright © 2019 I-Connect007. All rights reserved.