Barry Katz Discusses SiSoft's DesignCon Papers and Plans for 2018


Reading time ( words)

SiSoft President and CTO Barry Katz sat down with Editor Andy Shaughnessy to share his thoughts on the company's papers presented during DesignCon 2018, as well as SiSoft's latest products and plans for 2018.

To watch this interview, click here.

Share

Print


Suggested Items

Words of Advice: Making Life Easier for Fabrication and Assembly

06/27/2019 | I-Connect007 Research Team
In a recent survey, we asked the following question: What steps do you take to make the job easier for your fabrication and assembly providers? Here are a few of the answers, edited slightly for clarity.

Words of Advice: Component Shortages in 2019

02/28/2019 | Andy Shaughnessy, Design007 Magazine
In a recent survey, we asked the following question: What components do you expect to be in short supply in 2019? Here are just a few of the answers, edited slightly for clarity.

Cadence Presents New Software System and Technical Papers at PCB West 2018

11/06/2018 | Nolan Johnson, PCB007
During PCB West 2018, I spoke with Dan Fernsebner, product marketing group director, and Hemant Shah, product management group director for enterprise PCB products, both with Cadence Design Systems, about their new software launch—DesignTrue DFM Ecosystem. Fernsebner and Shah also address recent technical papers from Cadence on Industry 4.0, IPC-2581, system-level design, and return-path analysis and management.



Copyright © 2019 I-Connect007. All rights reserved.