Register for Nine Dot Connects' December 20 Webinar: Spelunking in the Altium Schematic Preferences, Part 2


Reading time ( words)

In November Nine Dot Connects began their exploration of the Altium Designer schematics preferences. This included a thorough look at the general, grids, break wire and default units pages. This month Nine Dot will look at the following schematic preference pages in detail:

  • Graphical Editing
  • Compiler
  • AutoFocus
  • Library Autozoom
  • Default Primitive Pages

If you missed part one, feel free to click on the link below to request the recording. In addition, files used for the presentation are also available for download. Click here to gain access to them.

This follow-up webinar is scheduled for December 20, 2017 at 2 pm Eastern Time.

For more information or to register, click here.

 

Share


Suggested Items

At GreenSource, Lean and Green Starts on the Front End

11/29/2018 | Andy Shaughnessy, Design007 Magazine
GreenSource is the first new captive shop in American in decades, and one of the first waste-free board shops as well. The CAM engineers all work remotely, and they can launch a job without ever entering the facility. I spoke with JanNell Taylor and Andy Schilloff, who work at the CAM office in New York. We discussed what it’s like working for a company that plays by its own rules, and what they're doing to get ready for the day GreenSource goes commercial

PCB Carolina 2018 Draws a Crowd of Technologists

11/16/2018 | Andy Shaughnessy, Design007 Magazine
PCB Carolina 2018, the one-day tabletop show based in Raleigh, North Carolina, drew quite a crowd to the McKimmon Conference and Training Center at NC State University on November 7. Show managers Tony Cosentino, Randy Faucette, and Lance Olive (all employees of the Better Boards service bureau) said that this year’s event showed signs of growth compared to the 2017 show, which was also larger than the previous year. They estimated that about 1,000 people attended this year, and they expect another increase in attendance in 2019.

Mentor and TEXMAC Takaya Team up to Optimize DFT

10/24/2018 | Real Time with...SMTAI
At SMTAI, Mark Laing of Mentor, a Siemens Business, and Dave Levine of TEXMAC Takaya, sat down with Editor Nolan Johnson to discuss design for test, and their collaboration to improve DFT in PCB design tools and test machinery. They also traced the evolution of DFT over the past decade as it has begun to "left-shift" farther into the realm of the designer, all the way up to schematic entry.



Copyright © 2018 I-Connect007. All rights reserved.